Thingiverse
Tyongeee trophy
di Valnar_D
0
Download
1
Likes
0
Makes
I made a trophy for the one and only korean Auntie. I remixed the leg from an anime figure and found a cute octopus online and gave it a spanking device.
I made it in several parts so everything can be printed without supports except for a small one under the high heel. The leg and the octpus are printed with the highest possible quality which in my case was a layer height of 0.12mm. The T-bar can be printed at lower qualities so I used 0.28mm. I recomment to print the T-bar outer Walls first to make sure the hole is big enough but you can also shave the bolt on the leg a bit down if it doesn't fit instead. Then everything is glued together.
The SPANK ME paddle is just part of the Octopus and then carefully painted with black marker. If you are careful enough, the paint doesn't flow into the letters but wil stay on the outside and you get the actually look of Auntie's newest spanking device with the red Letters. Use a piece of tape on the face of the octopus to avoid painting h
I made it in several parts so everything can be printed without supports except for a small one under the high heel. The leg and the octpus are printed with the highest possible quality which in my case was a layer height of 0.12mm. The T-bar can be printed at lower qualities so I used 0.28mm. I recomment to print the T-bar outer Walls first to make sure the hole is big enough but you can also shave the bolt on the leg a bit down if it doesn't fit instead. Then everything is glued together.
The SPANK ME paddle is just part of the Octopus and then carefully painted with black marker. If you are careful enough, the paint doesn't flow into the letters but wil stay on the outside and you get the actually look of Auntie's newest spanking device with the red Letters. Use a piece of tape on the face of the octopus to avoid painting h
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!