Thingiverse
Ukulele strap clip
von haakemon
12
Downloads
3
Likes
0
Makes
I'm moving all my files to printables.com. This model is now available here: https://www.printables.com/model/36057-ukulele-strap-clip
Designed from scratch in Fusion 360, but used the design from ARC7217 as a starting point.
Slightly longer so that the hole to put the strap in goes outside the Ukulele body (at least it does on mine :) )
The clip is also narrower near the edge so that the clip will stay in place. The narrowest part is 2.25mm, and the widest part is 3mm.
I also made the bottom round, so it will fit my Ukulele more snugly. This will fit a Ukulele with a 60mm diameter hole snugly, but might work for others as well.
Designed from scratch in Fusion 360, but used the design from ARC7217 as a starting point.
Slightly longer so that the hole to put the strap in goes outside the Ukulele body (at least it does on mine :) )
The clip is also narrower near the edge so that the clip will stay in place. The narrowest part is 2.25mm, and the widest part is 3mm.
I also made the bottom round, so it will fit my Ukulele more snugly. This will fit a Ukulele with a 60mm diameter hole snugly, but might work for others as well.
haakemon veröffentlicht auch auf
18 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
