Thingiverse
ULN2003 base
von MrVictory
0
Downloads
1
Likes
0
Makes
This is a base to set the ULN2003 on. I made this for the Halloween Horror Movie Lithphane https://www.thingiverse.com/thing:2607210.
Check fit after printing then glue inside base. Then set ULN2003 on pegs and apply a small drop of glue on each peg to hold ULN down.
Check fit after printing then glue inside base. Then set ULN2003 on pegs and apply a small drop of glue on each peg to hold ULN down.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!