Thingiverse
Ultimaker Trap nut
door trget
2
Downloads
2
Likes
0
Makes
this is a replacement for the brass fitting in the ultimaker. the nut used is a 3/8"-12 acme thread. The design fits like a glove in the ultimaker print bed set up. There are 3mm holes for retaining screws, but they are not needed (they are actually in the wrong place... but because they are not used I never fixed it).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
