Thingiverse
Ultimate Bridge Test
von ItsAustinSea
2
Downloads
1
Likes
0
Makes
Single Strand, multiple length bridge limit tester. Printing at 1:1 scale measures from 1/8" and gradually increases to 2" increments. Printing at 2:1 scale will double that.
If the bridge filament strand in V1 is too thin for your printer to register, try V2 instead.
If the bridge filament strand in V1 is too thin for your printer to register, try V2 instead.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
