Slicer Discord
Under-desk Horizontal Spool Holder – 3D-Druckmodell von Thingiverse Thingiverse

Under-desk Horizontal Spool Holder

von walter
41 Downloads
61 Likes
0 Makes
Zum Modell
Filament spool holder that can be mounted under a desk, holds the spool horizontally. The top plate is attached to the bottom of the desk using screws or double sided tape. The lower holder goes through the spool and snaps magnetically to the top plate. The lower part and spool rotates around the thrust bearing. Useful for those who have issues with keeping horizontal surfaces clear.

There are two different spool posts, a short version that works with most narrow spools or spools with an inset (e.g. Atomic Filament), and a longer version that works with most spools, including the wider ones.

Uses a [14mm thrust bearing*](https://www.banggood.com/10pcs-F6-14M-6x14x5mm-Axial-Ball-Thrust-Bearing-6-x-14-x-5mm-p-1160827.html?p=EY011634303112016018) and [15mm magnets*](https://www.banggood.com/5pcs-N50-15mm-x-3mm-Strong-Round-Cylinder-Magnets-Rare-Earth-Neodymium-Magnets-p-984648.html?p=EY011634303112016018). I used 3 magnets on top and 5 on the bottom, that should be strong enoug
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Polycarbonate
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen