Unleashed

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA BambuLab Basic BambuLab Green Transmission Distance: 2PLA BambuLab Basic Yellow Transmission Distance: 6PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Gray Transmission Distance: 2PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 6 unique filaments. Substitute as needed. Swap Instructions:Start with BambuLab GreenAt layer #5 (0.48mm) swap to YellowAt layer #13 (1.12mm) swap to BlackAt layer #18 (1.52mm) swap to Blue GrayAt layer #20 (1.68mm) swap to GrayAt layer #23 (1.92mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe jus