Thingiverse
usb microscope focus stack
by ekaggrat
854
Downloads
653
Likes
10
Makes
I remodeled the original model to make it much more sleeker and use a lot less plastic.
there are two slide models . depending on the calibration of the printer one is a bit tighter than the other.
you need m2.5 x 6mm x 5 thread inserts to assemble this
also m2.5 x 6mm countersink screws.
there are two slide models . depending on the calibration of the printer one is a bit tighter than the other.
you need m2.5 x 6mm x 5 thread inserts to assemble this
also m2.5 x 6mm countersink screws.
ekaggrat also publishes on
25 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
