Thingiverse
usb microscope focus stack
por ekaggrat
854
Descargas
653
Likes
10
Makes
I remodeled the original model to make it much more sleeker and use a lot less plastic.
there are two slide models . depending on the calibration of the printer one is a bit tighter than the other.
you need m2.5 x 6mm x 5 thread inserts to assemble this
also m2.5 x 6mm countersink screws.
there are two slide models . depending on the calibration of the printer one is a bit tighter than the other.
you need m2.5 x 6mm x 5 thread inserts to assemble this
also m2.5 x 6mm countersink screws.
ekaggrat también publica en
25 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
