Thingiverse
Variable plate cell
door scarou
8
Downloads
5
Likes
0
Makes
Improvement of the initial variable plate cell. Now using a GT2 belt to move the plates instead of the previous complex nylon thread system.
Beware! You may learn something...
You will need:
- closed loop rubber GT2 timing belt 180-2GT-6.
- Stainless steel 4x M3x15 mm screws
- Stainless steel 8x M3x10 mm screws
- M5 threaded rod for the drive shaft
- 2 x Stainless steel plate for electrodes (the size you want. Could be in 304 material but not necessary)
- Something to connect the plates. (I usually use stainless steel metal cable ties)
https://youtu.be/JcV2RfEz2I0
Beware! You may learn something...
You will need:
- closed loop rubber GT2 timing belt 180-2GT-6.
- Stainless steel 4x M3x15 mm screws
- Stainless steel 8x M3x10 mm screws
- M5 threaded rod for the drive shaft
- 2 x Stainless steel plate for electrodes (the size you want. Could be in 304 material but not necessary)
- Something to connect the plates. (I usually use stainless steel metal cable ties)
https://youtu.be/JcV2RfEz2I0
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
