VelocityOne Flaps and Spoiler Control Knobs

This is the latest creation for my VelocityOne controller for MS Flight Simulator.

I created the knobs because it makes it easier for me to remember the assignments in my profiles.

To print these you might need to cut the model to print 5mm of the sleeve that fits over the V1F shaft and scale the model to fit. Different printers will be more or less accurate with small shapes. The sizes in the two knob designs fit my printer. But they are both different because on my printer the accuracy achieved with white filament is different to what comes out from black filament. Be sure to check fitting using the top of the small section because as you will know the base needs trimming anyway because the face sitting on the platen will always have a ridge that must be trimmed.

The storage box is there because I am notorious at loosing bits for my tech gadgets

I have also included photos of my setup with all of the designs fitted. The other designs are all downloaded to the site.