Thingiverse
Venturi
von crossfactor
19
Downloads
17
Likes
0
Makes
Venturi for airating ponds
Fits a standard garden hose and has an air intake that will fit an air hose with id( inner diameter of .5 inch)
use thread seal make sure of no leaks ( in testing no tread seal was used and no leaks were found)
Print with no supports ( support for the air intake is pre made into the design)
Remove the circle support by the threads
https://youtu.be/2PYW1a3smvE
Fits a standard garden hose and has an air intake that will fit an air hose with id( inner diameter of .5 inch)
use thread seal make sure of no leaks ( in testing no tread seal was used and no leaks were found)
Print with no supports ( support for the air intake is pre made into the design)
Remove the circle support by the threads
https://youtu.be/2PYW1a3smvE
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
