Thingiverse
Vertical Plotter
von owenlab
29
Downloads
23
Likes
0
Makes
This is an improvement of Unterwelt vertical plotter made by Antonio Ianiero (iant) and Makelangelo from Marginally Clever
Print 2 pulley and the Motor holder
Print/laser/engrave the template on a panel and then screw the motor holder with 4 M6 screw
Put 4 Vcarved bearing in the 4 angle of the template
put the electronic (Genuino Uno and Adafruit Motro shield) on the Motor mount
For the firmware and software you can use the awesome Makelangelo
https://github.com/MarginallyClever/Makelangelo
Print 2 pulley and the Motor holder
Print/laser/engrave the template on a panel and then screw the motor holder with 4 M6 screw
Put 4 Vcarved bearing in the 4 angle of the template
put the electronic (Genuino Uno and Adafruit Motro shield) on the Motor mount
For the firmware and software you can use the awesome Makelangelo
https://github.com/MarginallyClever/Makelangelo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
