Thingiverse
Vertical PS4 controller stand
von Maxso10
1
Downloads
7
Likes
0
Makes
This controller is for 2 PS4 controllers and it's devided in two parts: the base (15x10x1 cm), the support (20.8x2.5x1.5 cm). The base recess is 1 millimeter wider than the controller's support. If it's too wide you can put some glue in it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!