Vertical Server Mount

I created this model to mount my 2u Server vertically in an unfinished section of my basement. I printed with 5 wall loops and 20% infill. Print two, one should be mirrored. This model is customizable with the following BodyDepth: The depth of the server when vertical. So actually the server height. For my 2u Server this was 90mm.BodyWidth: The width of the part to support the server at its mount points. For me this was 19mmStudOffset: The offset needed to mount to studs. For me this was -3.175mm as my studs were just wider than the body of my server.MountStudDepth: The depth of the part that mounts to your stud.MountScrew: The Hole size for the screws to mount the part to your studsMountScrewHead: The size of the screw heads so screws can be sunkServerMountHoleOne: The location of the screw hole to mount your server to the part. This should be measured from the bottom of your server.ServerScrew: The size of the screw hole to mount the server to the part.