Thingiverse
Voltmeter case
door ccarrasco
47
Downloads
35
Likes
0
Makes
Another iteration of voltmeter case. Purchased on eBay, it is a very common and cheap device with 2 or 3 wires which are comming with just a PCB.
Use 2 x M2.5 hex screws on the back to securely close the case. Rectangle hole on the side is for wires.
6 x 2mm holes have been put on top and bottom for fixing it if required. Use M2.5 screws directly in the case.
Enjoy...
Use 2 x M2.5 hex screws on the back to securely close the case. Rectangle hole on the side is for wires.
6 x 2mm holes have been put on top and bottom for fixing it if required. Use M2.5 screws directly in the case.
Enjoy...
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!