Thingiverse
VTX Bracket
von spudinator
31
Downloads
26
Likes
1
Makes
Bracket to hold a vtx like TBS Unify or ImmersionRC Tramp above a flight controller.
**Warning**: If your VTX gets to hot it can warp PLA. Recommend putting sticky foam or something to insulate the VTX from the part.
30.5 x 30.5 mounting holes
There are 2 designs
Square1.stl
thin.stl
The thin one is probably the one you want
**Warning**: If your VTX gets to hot it can warp PLA. Recommend putting sticky foam or something to insulate the VTX from the part.
30.5 x 30.5 mounting holes
There are 2 designs
Square1.stl
thin.stl
The thin one is probably the one you want
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
