Thingiverse
Wake Shaper
von mpyr6
71
Downloads
64
Likes
1
Makes
This wake shaper was designed to be 3D printed and requires minimal hardware to be built. Using two suction cups to mount, there is no damage to the hull and can be switched from port to starboard in moments.
8/20/18 Update: Lost the shaper in the water this weekend. When printing make sure that the Body Back is printed sitting flat otherwise there is a 100% chance that the rear security loop will break. Working on a rev. 2 to combat this issue. In the meantime be aware of the curvature of the boat and confirm the mounting location is flat to provide the best seal for the suction cups. Happy surfing!
Video of it in action:
https://youtu.be/twSvmDqFn5o
Difference between Ballast Only and Wake Shaper with Ballast:
https://www.youtube.com/watch?v=oznU7mJ5vlE&feature=youtu.be
8/20/18 Update: Lost the shaper in the water this weekend. When printing make sure that the Body Back is printed sitting flat otherwise there is a 100% chance that the rear security loop will break. Working on a rev. 2 to combat this issue. In the meantime be aware of the curvature of the boat and confirm the mounting location is flat to provide the best seal for the suction cups. Happy surfing!
Video of it in action:
https://youtu.be/twSvmDqFn5o
Difference between Ballast Only and Wake Shaper with Ballast:
https://www.youtube.com/watch?v=oznU7mJ5vlE&feature=youtu.be
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
