Thingiverse
Wall Bracket
von CrankyBob
20
Downloads
13
Likes
0
Makes
I needed a bracket to store my spare bicycle wheels so I designed one in Fusion360 and printed it. I've increased the size of the countersink slightly from the brackets in the photo as I found that 8mm was just a fraction too small.
Turned out pretty good!
NB: I'm not planning on hanging anything more than a couple of kilos on it so the strength is good for my purposes.
Turned out pretty good!
NB: I'm not planning on hanging anything more than a couple of kilos on it so the strength is good for my purposes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
