WALL-E (electronics brackets)

I made up various brackets to mount electronic components inside the WALL-E design from chillibasket's project.

- I use M2 machine screws to mount the parts to the brackets.
- Hot Glue to fasten the brackets to the walls inside the WALL-E body
(easy to remove if needed to move them to get the right position due to internal component conflicts)

Here is the parts I used, I got from (Banggood.com)
- PCA9685 16-Channel 12-bit PWM Servo Module
- DOIT ESP32 DEVKIT V1 Board I got from (36pin version)
- L298N Dual H Bridge Stepper Motor Driver Board
- 5 Amp Adjustable DC-DC Step Down Module Power Supply Converter
- DFPlayer module
- Ywrobot speaker module Speaker 8ohm 0.5 watt (it is a 50mm diameter speaker)

The ESP bracket I have 3 versions, but I used the removable version.
(you mount/glue the BracketLock_ESP32_36pin.stl print to the wall then you can push and turn the Bracket_ESP32_36pin.stl printed bracket you attach the ESP32 keep it in place)

If anyone requires I ca