Thingiverse
Wall support for panel
von Raskolnikov_
0
Downloads
0
Likes
0
Makes
I designed this minimalist support for this painting that was a gift.
It is for 27mm thickness of the wood and the diagonal is 37.5mm.
I included the SLDPRT file if you want to modify some parameters!
The holes for the screws are 5.5mm so the can accommodate M5 and smaller screws.
In my case I used some M4 screws and it worked well.
Use tree option for the support it is really easier to remove and it does not mess with the fit.
It is for 27mm thickness of the wood and the diagonal is 37.5mm.
I included the SLDPRT file if you want to modify some parameters!
The holes for the screws are 5.5mm so the can accommodate M5 and smaller screws.
In my case I used some M4 screws and it worked well.
Use tree option for the support it is really easier to remove and it does not mess with the fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!