Thingiverse
Wallmount screwdriverrack
von s0h0punk
8
Downloads
5
Likes
1
Makes
A 'universal' wallmount screwdriverrack. Holds 21 screwdrivers.
Print at 100% for your average screwdrivers - 120% or larger for those few really big ones (if your print bed is large enough).
spacing between the holes at 100% is 2.5cm (so handles up to 5cm in diameter fit).
For best results, lay it top down in your slicing software since that's the biggest flat area.
I had some underextrusion at the end (you can see it in the final pictures), because my spool decided to leave the table mid-print.
This is my first design, so any constructive criticism is welcomed!
Also see the remixed version with better wall clearance
Print at 100% for your average screwdrivers - 120% or larger for those few really big ones (if your print bed is large enough).
spacing between the holes at 100% is 2.5cm (so handles up to 5cm in diameter fit).
For best results, lay it top down in your slicing software since that's the biggest flat area.
I had some underextrusion at the end (you can see it in the final pictures), because my spool decided to leave the table mid-print.
This is my first design, so any constructive criticism is welcomed!
Also see the remixed version with better wall clearance
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
