Thingiverse
Wallmounted Thread BIG Spool Holder
von sebasamd
1
Downloads
1
Likes
0
Makes
I enlarged the support to 10cm and reduced the amount to fit the bed of the ender 3.
threadholderwall.stl : its the braket to the wall
threadholder.stl: 4 holders, same thats the original but 5cm longer. (10cm total)
thread3holders.stl: 10cm long but only 3 holders to fit 35mm diameter spoolers.
I printed with PETG, for holders 30% infill and 50% for the braket.
threadholderwall.stl : its the braket to the wall
threadholder.stl: 4 holders, same thats the original but 5cm longer. (10cm total)
thread3holders.stl: 10cm long but only 3 holders to fit 35mm diameter spoolers.
I printed with PETG, for holders 30% infill and 50% for the braket.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!