Thingiverse
WCU4 Trigger
von BlitzR
9
Downloads
9
Likes
0
Makes
After the print is done, you need to tread the push rod to M3 metric and use a M3 x 8mm Hex bolt
This trigger has to be attached to the WCU using foam double side tape such as 3M or equivalent.
This trigger has to be attached to the WCU using foam double side tape such as 3M or equivalent.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!