Thingiverse
wESP32 Case
von notjj
4
Downloads
5
Likes
0
Makes
Two part case for the Silicognition wESP32 board.
The case is made to accept M2.5 inserts. M2.5x3 fit in the recesses for the board and M2.5x6 in the recesses for the case top.
Options Include an opening on the back to access the programming pin holes on the board. Depending on your USB cable you may need to use a female socket header to extend the legs on the programmer to make good contact.
Mounting tabs are offset to not not overlap the ethernet port of the board.
The case is made to accept M2.5 inserts. M2.5x3 fit in the recesses for the board and M2.5x6 in the recesses for the case top.
Options Include an opening on the back to access the programming pin holes on the board. Depending on your USB cable you may need to use a female socket header to extend the legs on the programmer to make good contact.
Mounting tabs are offset to not not overlap the ethernet port of the board.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!