Thingiverse
Animals
Zum Modell
Whelpling
31
Downloads
29
Likes
2
Makes
I was not able to find a cute baby dragon my wife could hang from her rear view, so I made this one.
I printed laying down, with wings and tail touching a raft. As the supports are small and complex I used a lower speed than usual to print.
I used 3 MM thick walls with 5% infill - Wings made thicker to ensure stability
I printed laying down, with wings and tail touching a raft. As the supports are small and complex I used a lower speed than usual to print.
I used 3 MM thick walls with 5% infill - Wings made thicker to ensure stability
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
