Thingiverse
Wifi Plug
par examiner
0
Téléchargements
2
Likes
0
Makes
This is a 3D-printable [OpenSCAD](https://openscad.org/) plug to fill up those empty WIFI antenna holes left behind when you remove the WIFI capability from your computer.
##### Model and Parts
The model consists of a bolt and fastener, with the fastener available in two forms (cap or nut).
###### Bolt
The bolt is a 1/4"-20 UNC thread, that has been "squared-off" on one side. Standard threading for antennas is a finer 1/4"-36 UNS, but the coarse thread prints easier.
###### Cap
A knurled cap that matches the bolt. It is slightly longer than the bolt so it should completely cover the bolt.
###### Nut
A nut that matches the bolt is provided, mostly for convenience. Either the cap or the nut is needed, not both.
##### Printing
I use a Creality Ender 3 Pro to build from PLA with a **layer height of 0.12 mm**.
**N.B.** The bolt part is sized to the exact specification of the metal parts (6.35mm outer diameter with 5.85mm across the flat part), but, depending
##### Model and Parts
The model consists of a bolt and fastener, with the fastener available in two forms (cap or nut).
###### Bolt
The bolt is a 1/4"-20 UNC thread, that has been "squared-off" on one side. Standard threading for antennas is a finer 1/4"-36 UNS, but the coarse thread prints easier.
###### Cap
A knurled cap that matches the bolt. It is slightly longer than the bolt so it should completely cover the bolt.
###### Nut
A nut that matches the bolt is provided, mostly for convenience. Either the cap or the nut is needed, not both.
##### Printing
I use a Creality Ender 3 Pro to build from PLA with a **layer height of 0.12 mm**.
**N.B.** The bolt part is sized to the exact specification of the metal parts (6.35mm outer diameter with 5.85mm across the flat part), but, depending
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !