Thingiverse
Wifi Plug
von examiner
0
Downloads
2
Likes
0
Makes
This is a 3D-printable [OpenSCAD](https://openscad.org/) plug to fill up those empty WIFI antenna holes left behind when you remove the WIFI capability from your computer.
##### Model and Parts
The model consists of a bolt and fastener, with the fastener available in two forms (cap or nut).
###### Bolt
The bolt is a 1/4"-20 UNC thread, that has been "squared-off" on one side. Standard threading for antennas is a finer 1/4"-36 UNS, but the coarse thread prints easier.
###### Cap
A knurled cap that matches the bolt. It is slightly longer than the bolt so it should completely cover the bolt.
###### Nut
A nut that matches the bolt is provided, mostly for convenience. Either the cap or the nut is needed, not both.
##### Printing
I use a Creality Ender 3 Pro to build from PLA with a **layer height of 0.12 mm**.
**N.B.** The bolt part is sized to the exact specification of the metal parts (6.35mm outer diameter with 5.85mm across the flat part), but, depending
##### Model and Parts
The model consists of a bolt and fastener, with the fastener available in two forms (cap or nut).
###### Bolt
The bolt is a 1/4"-20 UNC thread, that has been "squared-off" on one side. Standard threading for antennas is a finer 1/4"-36 UNS, but the coarse thread prints easier.
###### Cap
A knurled cap that matches the bolt. It is slightly longer than the bolt so it should completely cover the bolt.
###### Nut
A nut that matches the bolt is provided, mostly for convenience. Either the cap or the nut is needed, not both.
##### Printing
I use a Creality Ender 3 Pro to build from PLA with a **layer height of 0.12 mm**.
**N.B.** The bolt part is sized to the exact specification of the metal parts (6.35mm outer diameter with 5.85mm across the flat part), but, depending
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!