winch computer case

This case is for a feather with oled display, very small battery, amp and speaker. USB port is a bit low but perfectly accessible. I did forget to make a notch for the wire which goes to the sensor but I "added" it with a soldering iron. The switch is depressed and then slid into place and secured with a bit of folded paper or tape. I used M2*16 screws to hold the boards in place and heated the nuts to sink them into the pockets, which are a bit small. I taped a scrap to the top in lieu of a proper top. This case isn't perfect but I didn't mark this as "work in progress" because it works for me and I'm not planning on working on it.

Adafruit FeatherWing OLED - 128x32 OLED Add-on For Feather PID: 2900
Lithium Ion Polymer Battery - 3.7v 150mAh PID: 1317
Adafruit Mono 2.5W Class D Audio Amplifier - PAM8302 PID: 2130
Mini On/Off Push-Button Switch PID: 3870
Mini Oval Speaker - 8 Ohm 1 Watt PID: 3923

https://youtu.be/dAYnz74ZBcQ