Wind Spinner

Description BEARING VERSION NOW AVAILABLE! - https://makerworld.com/en/models/439471#profileId-345050   Here's a straightforward 13inch wind spinner designed for your yard, no bearings required. I might possibly add bearings to this at a later time for a smoother spin but it works fine the way it is. I would recommend printing this in PETG for optimal durability although High Temp PLA could serve as an alternative which is what I used. 3/8inch or smaller dowel rod to mount it in the ground. *NOTE* - Would recommend super glue on the Cap screw to keep it from backing out over time.   Directions: ( See photo for reference ) STEP 1 - Place the wind fins into the puzzle locking "BOTTOM PART". STEP 2 - Screw on the “TOP PART” to connect the fins to the “BOTTOM” STEP 3 - Slide the connected fins onto the “MAIN PART” STEP 4 - Screw on the “CAP PART” STEP 5 - Insert a 3/8inch dowel rod or something close to that size. DONE! Optional Mounting - If you want to mount it horizontally you only need to swap out one of the “CAP PARTS” with the “HORIZONTAL PART”