Thingiverse
Windmill Vane
von Joe95online
8
Downloads
7
Likes
0
Makes
Windmill Vane i designed using Fusion 360
Printed in Brown PLA
Uses 2 Bearings 18MM outside 12mm inside
I recommend you use 40%+ supports for the wheel part
Thanks for looking.
Printed in Brown PLA
Uses 2 Bearings 18MM outside 12mm inside
I recommend you use 40%+ supports for the wheel part
Thanks for looking.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!