Thingiverse
Wing
by JGAF
1
Downloads
0
Likes
0
Makes
Remote Control Slope Glider
https://youtube.com/shorts/MSIswYUa8xs?si=016Roo3bg9eDxom5
Aka "Wing" by @jgaf on YouTube & Instagram
If you like it & want to support:
https://www.paypal.me/slopecorn
any questions email [email protected]
Required to complete:
2x 9gram or smaller/thinner servos
1s lipo battery 500mah+
End plug receiver
Optional switch or extension
Filaments:
LW Active Foaming (do not use pre-foamed) PLA
PETG
85a+ TPU
Elevator travel 1/5"
Aileron travel 1/2"
Glue servo wrapped in electrical tape to underside of cover & insert in wing. receiver/battery up to you, I just hot glued mine in with low temperature hot glue for easy removal later.
download aileron control horn found on my page, cut slot in elevon & use CA and kicker to glue in place.
control rods = 2mm carbon fiber rod or equivalent strength, z bends, clevises (included) etc.
This is not and does not fly like a beginner model, if you can't make up a control
https://youtube.com/shorts/MSIswYUa8xs?si=016Roo3bg9eDxom5
Aka "Wing" by @jgaf on YouTube & Instagram
If you like it & want to support:
https://www.paypal.me/slopecorn
any questions email [email protected]
Required to complete:
2x 9gram or smaller/thinner servos
1s lipo battery 500mah+
End plug receiver
Optional switch or extension
Filaments:
LW Active Foaming (do not use pre-foamed) PLA
PETG
85a+ TPU
Elevator travel 1/5"
Aileron travel 1/2"
Glue servo wrapped in electrical tape to underside of cover & insert in wing. receiver/battery up to you, I just hot glued mine in with low temperature hot glue for easy removal later.
download aileron control horn found on my page, cut slot in elevon & use CA and kicker to glue in place.
control rods = 2mm carbon fiber rod or equivalent strength, z bends, clevises (included) etc.
This is not and does not fly like a beginner model, if you can't make up a control
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!