Wing

Remote Control Slope Glider
https://youtube.com/shorts/MSIswYUa8xs?si=016Roo3bg9eDxom5

Aka "Wing" by @jgaf on YouTube & Instagram

If you like it & want to support:
https://www.paypal.me/slopecorn

any questions email [email protected]

Required to complete:
2x 9gram or smaller/thinner servos
1s lipo battery 500mah+
End plug receiver
Optional switch or extension

Filaments:
LW Active Foaming (do not use pre-foamed) PLA
PETG
85a+ TPU

Elevator travel 1/5"
Aileron travel 1/2"

Glue servo wrapped in electrical tape to underside of cover & insert in wing. receiver/battery up to you, I just hot glued mine in with low temperature hot glue for easy removal later.

download aileron control horn found on my page, cut slot in elevon & use CA and kicker to glue in place.

control rods = 2mm carbon fiber rod or equivalent strength, z bends, clevises (included) etc.

This is not and does not fly like a beginner model, if you can't make up a control