Thingiverse
wingnut socket
von mandyn
1
Downloads
3
Likes
0
Makes
Designed to go on a 1/2" socket drive (13mm).
Print 100% infill, with supports, PLA, worked very well and didn't slip from wingnuts.
Battle tested with a 300nm torque impact wrench.
Print 100% infill, with supports, PLA, worked very well and didn't slip from wingnuts.
Battle tested with a 300nm torque impact wrench.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
