Thingiverse
Wings Split
von OsmannyM
0
Downloads
0
Likes
0
Makes
- To attach the split wings you will have to cut 9 14mm pieces of filament to insert and properly align the two pieces.
* Sometimes the holes are not big enough due to that face printing directly on the bed but you can widen the holes slightly using a small screwdriver or another small tool.
* You may add super glue between the two wing pieces for a secure fit.
* Sometimes the holes are not big enough due to that face printing directly on the bed but you can widen the holes slightly using a small screwdriver or another small tool.
* You may add super glue between the two wing pieces for a secure fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
