Workable Wind-Mill

This is a funny windmill, it works very nice under nature wind outdoor.

To finish this windmill, you may need the following parts:

1. Ball bearing 2pcs, i prefer MR105ZZ
2. Steel pin 1pc, 5x50mm, match your bearings.
3. Glass fiber bars 5x350-400mm 1pc, 8x400mm 1pc, you may use steel bar or carbon fiber bar as well.
4. A coil plate for pla/ABS as foundation, you'd better draw a part by yourself, that will fit your plate very well.

You should try different tolerances of some parts to make the wheel run easily and others fix tightly.

Hope you will like this thing......good luck!