Wrap Master Wall Bracket

I created this bracket for a couple of Wrap Master Dispensers I picked up for my wife in a thrift store. The dispensers work amazing, but are rather large and take up valuable cabinet or counter space. So I decided they would look good on the wall. I wanted the bracket not only to support / store the Wrap Master, But I wanted to be able to dispense from it while it was on the wall. These work and look even better than I anticipated.

V1 is pretty rough, square edges and teh lower screw hole is a little off center.

V2 is much better, with the hole centered properly and Filleted edges as well for a more finished look.

I didn't use a brim on the V1 and it printed fine, the Filleted V2 however did not print well without one. That was on Blue Mask. Might add some final Net and see if that helps.

Hopefully at least one other person finds this useful.