XTouch Total Screen Replacement

Have been using the 2.8-inch touchscreen for a while now and decided to finally remove the original screen. https://github.com/xperiments-in/xtouch I remixed the one I posted a while back and used the outline of one off of Printables for the back. Added a cutout to access the reset button - just in case. Made it fit close to the frame and only wide enough to cover up the screws in the front plate. This means you cannot use a straight micro-USB cable! POWER OPTIONS:Use the 4-pin cable provided with the ESP32 screen and either solder splice to a USB A connector or use a USB breakout device.Purchase a 4-pin JST 1.25mm to USB A cable from the internet (saw them on AliExpress). Check pinout before using!!!!Purchase a “LEFT” angle micro-USB cable, but you would have a hard time getting it routed through the opening in the front plate.Cut away at the plastic covering and removing any metal strain reliefs (what I did).HARDWARE REQUIRED:(1) ESP32-2432S028R(4) M3x12 cap head screws(1) Power opti