Thingiverse
Y-Motor-Support 3d-plexi-printer
door steijlen
6
Downloads
10
Likes
0
Makes
This is a y-motor-support for my new to build plexi-printer. (Plexi because I am going to make this printer from Polystyrene / clear Plexiglas).
You can look at the pictures to see how it is meant to be used.
It will be mounted to the back and to the right-side. In the right-back corner. About 80 mm from the top.
The motor can be adjusted to keep the belt tension right. I will probably use a 160Lx6Wmm T2.5 timing belt.
It will support a NEMA-17 motor.
You can look at the pictures to see how it is meant to be used.
It will be mounted to the back and to the right-side. In the right-back corner. About 80 mm from the top.
The motor can be adjusted to keep the belt tension right. I will probably use a 160Lx6Wmm T2.5 timing belt.
It will support a NEMA-17 motor.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
