Thingiverse
Z-Axis Endstop Bracket
door rickys0420
1
Downloads
2
Likes
0
Makes
I needed a simple Z-Axis end-stop mount that I could use on either side of my printer (for dual z end-stops) and that would attach to the extrusion.
With this setup, the end-stop is hitting the v-slot wheel or metal spacer (if using linear rails).
It can easily be adjusted by moving the bracket up or down the extrusion as needed.
There are indentions for the back of the end-stop, where the soldering took place. Should be plenty of space for the mounted endstop.
You will need some hardware; M5 screws and T-Nuts, end-stop, and M3 screws.
With this setup, the end-stop is hitting the v-slot wheel or metal spacer (if using linear rails).
It can easily be adjusted by moving the bracket up or down the extrusion as needed.
There are indentions for the back of the end-stop, where the soldering took place. Should be plenty of space for the mounted endstop.
You will need some hardware; M5 screws and T-Nuts, end-stop, and M3 screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!