Thingiverse
zero-bs
von Alex_Thunder
29
Downloads
28
Likes
0
Makes
I searched for a compact 3.5'' display case for the pi zero but everything i found was larger for the pi 2/3 so i designed this.
the case is very compact and requires soldering. you will need to remove the female header from the 3.5'' TFT and solder the pi zero/w directly to the back of the display.
depending on the specific LCD/TFT display you have, you may need to do more to make everything fit. In my case, i needed to remove the micro-usb power port from the PI zero to get the pi to lay flat because there was a chip on the back of the TFT display at that spot.
The case has a 4mm hole at the base for a dedicated power cable and a 4mm hole on the back for a soft power / shutdown button
follow this excellent guide to setup a no hassle power/shutdown button:
https://howchoo.com/g/mwnlytk3zmm/how-to-add-a-power-button-to-your-raspberry-pi
the case is very compact and requires soldering. you will need to remove the female header from the 3.5'' TFT and solder the pi zero/w directly to the back of the display.
depending on the specific LCD/TFT display you have, you may need to do more to make everything fit. In my case, i needed to remove the micro-usb power port from the PI zero to get the pi to lay flat because there was a chip on the back of the TFT display at that spot.
The case has a 4mm hole at the base for a dedicated power cable and a 4mm hole on the back for a soft power / shutdown button
follow this excellent guide to setup a no hassle power/shutdown button:
https://howchoo.com/g/mwnlytk3zmm/how-to-add-a-power-button-to-your-raspberry-pi
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
