Slicer Discord
ZigZag Easter Egg – 3D printable model from Thingiverse Thingiverse

ZigZag Easter Egg

by dazus
60 Downloads
45 Likes
0 Makes
Go to Model
**KEEP MAGNETS AWAY FROM SMALL CHILDREN. Magnets can come loose. If swallowed, magnets can be FATAL.**


####Not To Be Sold
**I'm sharing my files so that you can make them for yourselves or give them away as gifts. I hope you enjoy them. I do not authorize sale of my work by anyone. Please don't ask me.**

####About The Design
Another fun Easter Egg design. It uses 3x2mm magnets to told the two pieces together. 4 magnets on each half are more than enough, but I put 8 holes in so you could change the pattern up by rotating the top 45 degrees relative to the bottom.


**Quick Tips:** The easiest way I've found to install the magnets is to get a larger rod-shaped magnet (some magnet sets come with them) and place a 3x2 magnet on the end. Put a drop of CA glue in the hole in the egg. Put a drop of kicker (aka “insta-cure” or “activator”) on the magnet, then use the larger magnet to install the smaller one in the egg and slide the pushed magnet sideways off the egg. The 3x2 magne
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Why?
significant post-processing
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 2/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Gluing, Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection