Thingiverse
Zipper pull
von pmanousis
4
Downloads
2
Likes
0
Makes
Has it ever happened to you that your zipper pull brakes?
I created a two part zipper pull, the first part is the one you insert into the hole of your slider, and then you put the other part so as to enclose it. I also used some glue to keep the two parts together.
2023-10-16 update: the pull was kind of hard to get into the slider, so a new version with less material near the hole is easier to get there.
I created a two part zipper pull, the first part is the one you insert into the hole of your slider, and then you put the other part so as to enclose it. I also used some glue to keep the two parts together.
2023-10-16 update: the pull was kind of hard to get into the slider, so a new version with less material near the hole is easier to get there.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!