Slicer Discord
"Zombie set" version 1 – 3D-Druckmodell von MyMiniFactory MyMiniFactory
Fantasy Universe

"Zombie set" version 1

0 Downloads
10 Likes
0 Makes
Zum Modell
"Zomdie set" version 1 for 32mm format, height from bottom to eye 28mm. "Zombies never walk alone. So, traveler, don't forget the surest tactic of the apocalypse: “Hide or Run”. One by one these dead dumbasses do not pose a threat, but when there are more than two of them, it is better to retreat. Usually, when you see a group of two or three zombies, it means that there is a so-called strike group nearby. So look around first, and then run away."   So this group is exactly the one you don't see. Zombies can be smart, and some have learned to hunt. While the one noisiest group of zombies takes the attention away from you, these quiet dead are stunning with their sudden appearance behind you. That's why it's useful for any stalker to have a good machete or bat behind their back to fight back in close combat. Although even here you may not stand much of a chance. You will at most be able to deal with one or two, but the third will reach the target. Even if you are lucky enough to ta
Kategorie
Fantasy Universe
Quelle
MyMiniFactory
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen