Thingiverse
2021 Snowflake Split
por silentcleric
5
Descargas
6
Likes
0
Makes
Hi All,
We love this ornament. My IDEX printer just would not handle the color split right. I just split the original so I could do a simple 2 mm layer of white on a red base. If you use Cura for the white .stl make sure you remove the setting that drops the white .stl to the plate. You may have to rotate the two .stl's just slightly for alignment
Big thanks to rkxone for a great 2021 ornament.
Robert-
We love this ornament. My IDEX printer just would not handle the color split right. I just split the original so I could do a simple 2 mm layer of white on a red base. If you use Cura for the white .stl make sure you remove the setting that drops the white .stl to the plate. You may have to rotate the two .stl's just slightly for alignment
Big thanks to rkxone for a great 2021 ornament.
Robert-
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!