Thingiverse
2021 Snowflake Split
door silentcleric
5
Downloads
6
Likes
0
Makes
Hi All,
We love this ornament. My IDEX printer just would not handle the color split right. I just split the original so I could do a simple 2 mm layer of white on a red base. If you use Cura for the white .stl make sure you remove the setting that drops the white .stl to the plate. You may have to rotate the two .stl's just slightly for alignment
Big thanks to rkxone for a great 2021 ornament.
Robert-
We love this ornament. My IDEX printer just would not handle the color split right. I just split the original so I could do a simple 2 mm layer of white on a red base. If you use Cura for the white .stl make sure you remove the setting that drops the white .stl to the plate. You may have to rotate the two .stl's just slightly for alignment
Big thanks to rkxone for a great 2021 ornament.
Robert-
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!