Thingiverse
220mm Version
von Woinson95
0
Downloads
2
Likes
0
Makes
I liked the spool holder for my I3 by garrettreed but wanted to use be able to use any width of spool. This may be a little excessive but you never know.
The base has been modelled with material relief in so it only takes the same amount of time as the original 180mm one.
I have created a 180mm one material relief too to save on material use.
The base has been modelled with material relief in so it only takes the same amount of time as the original 180mm one.
I have created a 180mm one material relief too to save on material use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
