Thingiverse
220mm Version
door Woinson95
0
Downloads
2
Likes
0
Makes
I liked the spool holder for my I3 by garrettreed but wanted to use be able to use any width of spool. This may be a little excessive but you never know.
The base has been modelled with material relief in so it only takes the same amount of time as the original 180mm one.
I have created a 180mm one material relief too to save on material use.
The base has been modelled with material relief in so it only takes the same amount of time as the original 180mm one.
I have created a 180mm one material relief too to save on material use.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
