Thingiverse
The Penmaker's Friend
by involved6
40
Downloads
17
Likes
1
Makes
A simple chuck that allows you to drill out the center of your blanks by using a standard 3-inch faceplate with a drill chuck on the tailstock. STL included is a single of 4 required, identical jaws.
No more lining things up in the vise for the drill press! Simply take your 3/4" blank and insert or tighten down into the jaws and crank away.
Jaws have two relief bands for pipe clamps, but I haven't seen a need for them yet, as this process is usually on the slowest setting on the lathe. Use
No more lining things up in the vise for the drill press! Simply take your 3/4" blank and insert or tighten down into the jaws and crank away.
Jaws have two relief bands for pipe clamps, but I haven't seen a need for them yet, as this process is usually on the slowest setting on the lathe. Use
Sign in to leave a comment
Sign in