608 Bearing Idler for GT2

This is a set of printed parts to make an Idler from a 608 bearing. The top and bottom caps snap onto the 608 bearing, and 2 bushings provide a 5M hole in the center.

04/29/2017 Added idler608_01B that is the same as the original except the height or the 2 bearing clips (2 larger parts) has been stretched by 0.25mm for better (depending on the filament used) clip holding.

NOTE: A touch glue may be needed to keep it all together, I'm not sure. I didn't use glue...yet and seems to be holdi